CAMalot crest CAMalot

Validate before you cut.
Control with confidence.

CAMalot checks your model and your G-code against your machine's real work envelope, spindle limits, and modal state — before a mistake costs a tool or finds a limit switch. Then drive the machine directly, with full jog, MDI, and E-STOP control, from one interface.

Get CAMalot → See what it does
CAMalot Advanced Mode showing the 3D viewport with a loaded model, work envelope, and machine profile.

What CAMalot does today

Real software, doing real checks — every claim on this page is backed by the interface, not a roadmap.

Model Analysis

Know it fits before you cut stock

Load a model and CAMalot checks its bounding box against your machine's actual work envelope — not a spec sheet, the real number for the machine you connected.

CAMalot analysis panel confirming a part fits within the Ghost Gunner 3 work envelope, with bounding box and volume detail.
Validation, Not Guesswork

Checked against the machine you own

Every G-code or .dd file gets checked against your machine's real spindle range, travel limits, and modal state. CAMalot doesn't assume a generic profile — it validates against the machine that's actually connected.

CAMalot machine reference panel listing envelope, spindle range, and drive type for every supported machine.
Full Machine Control

One interface, built for the machine in front of you

Jog, MDI, feed-rate override, E-STOP. Home your machine, load a program, run it, pause and resume — all without switching tools.

CAMalot controller panel with axis position readout, jog controls, feed override, and E-STOP.
Guided Setup

Not a machinist yet? Start in Easy Mode

Easy Mode walks you through material, tooling, and setup step by step. Advanced Mode is there the moment you don't need the hand-holding.

CAMalot Easy Mode wizard asking what material the part is made of, step 2 of 7.
Coming

Full CAM

CAMalot's toolpath engine is in active development. The validation and control layer you can use today is the same foundation the full CAM pipeline — model in, finished toolpath out — will run on. This is where the name is headed. It's not there yet, and we'd rather tell you that than have you find out after you've bought it.

Supported machines

Ghost Gunner 1 · Ghost Gunner 2 · Ghost Gunner 3 · Ghost Gunner 3-S · Coast Runner CR-1

CAMalot reads your machine's real identification on connect and checks every job against that machine's limits — not a generic profile. See full specs →